AWR Passenger Side Engine Mount for Mazda3 / Mazdaspeed3
Item #: AWR-4301
Price:$209.95
Price: $209.95Sale: $209.95
Status:
Ships in 2-3 weeks
Stiffness:
|
2004-2012 Mazda3 2.3 and Mazdaspeed3 passenger side motor mount.
Available now in 70 , 88 and 95 durometer, with 95 being the is stiffest. This is a fully fabricated steel motor mount and all items are laser cut CNC folded and Tig welded. They are then powder coated and assembled with our Energy Suspension urethane bushings and nickel plated steel inner sleeve for that long lasting durability. A definite improvement for those who are experiencing wheel hop or sagging factory mounts. This is the cure for sure. Couple this with our lower rear mount and soon to be released drivers side transmission mount.
Note: If you are ordering this item specifically for a Mazdaspeed3 please order 88 durometer bushing at a minimum, as the 70 durometer mount is not recommended for this application.
My PMM went out, OEM mount lasted till 151K miles before blowing out immediately after adding a cold air intake, new sensors, and full tune up.
Figured since I had much horsepowers (sarcastic tone) I would opt for a higher durability over the 70 Duro if you have done ANY performance mods or go hard from 0mph.
I Opted for the 88 Duro, installed in about a half hour with 17mm DEEP socket, extension and ratchet plus thread locker. Overall thoughts at 100 miles use so far; much more aggressive feel, glove compartment rattles but that's an easy fix. Slightly more engine feedback into the cabin, obviously, but definitely tolerable. Only downside was there were no TQ specs or instructions, though quite straight forward for even an amateur mechanic.