AEM Water/Methanol Failsafe Gauge

Item #: 30-3020
    List Price:$282.57 Price: $267.70
    You Save:
    $14.87 (5.3%)

    Status: Discontinued

    Today’s water/methanol injection systems have proven themselves as a viable means for effectively reducing engine inlet air temperatures and suppressing harmful detonation. This allows enthusiasts to reliably increase boost and advance ignition timing without the need for racing fuel. Despite the proven effectiveness and reliability of water/methanol injection, there exists a potential for engine damage if the water/methanol tank runs dry, if the pump stops working or more commonly if flow volume decreases due to fuel contamination, a clogged nozzle or a leak in the system.

    While failsafe devices for water/methanol are not new, competitors’ failsafe systems have limitations that do not allow them to completely protect your engine if the water/methanol injection system stops flowing. Most failsafe devices have settings for high and low range flow parameters, but only monitor flow at a single point. And, without actually calculating volume versus time to establish a flow rate, instead running the system at full blast and using the nozzle’s potential for flow as your established flow rate, it is impossible to know the actual flow of the water/methanol system. Short version: if you think you are flowing 500cc/min and are actually flowing 300cc/min, and you are relying on your failsafe to trigger an alarm at a single reference point using 500cc/min of flow as your reference, then you have created the potential for engine damage.

    Other competitors’ failsafe systems use a flow meter to establish water/methanol flow and utilize an external adjustment to trigger an alarm if the system does not detect maximum flow, using a time-delay strategy to compensate for part throttle operation. The problem is, water/methanol flow is rarely zero or maximum flow, and with all of the potential flow rates one can experience, a time delay strategy is not completely failsafe.

    • Actively monitors the entire water/methanol fuel injection curve to trigger an alarm event under any defined adverse condition!
    • Can be used on virtually all water/methanol injection systems with either 1/4" or 4mm OD tubing
    • "Auto Set" feature automatically creates baseline configuration
    • Built-in warning lights inform user of an alarm trigger
    • Internal data logger records all injection flow and alarm status data
    • Included high-tech analog gauge has black and white faceplates and bezels to match vehicle interior, and is programmable for either 0-500cc/min or 0-1000cc/min flow ranges
    • Gauge alarm and backlighting are user programmable to match interior lighting
    • Data analysis using AEMdata software.
    • Gauge mounts into a 2 1/16” (52mm) hole